Solution:

###### The peal-to-peal network connectino and test ########### The peal-to-peal network connct two PC network ports with no hub. a) Network cable: Please prepare a network cable with 10 BaseT RJ-45 connector on both sides. Then please Cut the cable and connect 1 XMT+ <------------> 3 RCV + 2 XMT - <------------> 6 RCV - 3 RCV+ <------------> 1 XMT + 6 RCV - <------------> 2 XMT - b) Test under DOS You may test the network communcication by use Realtek network utility such as Reset8019.exe, Reset8029.exe or Rset8139.exe. Choose network diagnose item. You will see the transmission and recivinng counts. c) Test in Windows 95,98,NT4 1. Check your if network adaptor work corrct in the Windows. It shows in the"network" item in the "Control Panel". 2. Add a TCP/IP protocal configuration 3. Add a network IP and subset mask address in TCP/IP. Example: IP: 111.111.111.111 Subnet Mask: 250.0.0.0 4.Disable "WINS resolution" in WINS configuration of TCP/IP properties. 5. Add a "NETBUI" protocal in network configuration. 6. Add " Clinet for Microsoft network" service in network configuration. 7. Add " Files and printers sharing for Microsoft networks" in network configuration. 8. Click " Finish" and reboot system. 9. Release computer access right by checking My computer -> C drive -> Click right bottom of mouse -> Shoose share level (Folder). 10. Must log in a user name for the MS network. 11. Check the network neighborhood and wait for a while ( Form serval seconds to 3 minutes) to see the other computer. Sometime you need to check the "reflash" from "View" item.