Solution:

######## Installation in a CPU card ########### The following steps is the procedure of installation: (1). Put a DOC on ROM 1 socket ( the first ROM socket ). (2). Choose a suitable SSD I/O address for your system on J6, J7. (Default setting is SSD disabled.) (3). Go into the BIOS setup( BIOS setup -> ADVANCED CMOS SETUP->Onboard SSD) to enable the SSD function. You should be not able to find this option on the first screen. It is on the bottom of the options and you have to use cursor keys to scroll up the screen until the bottom of window. (4). Save setup and exit BIOS. Press Alt-S to enter the setup window of SSD. In this window, plase choose the suitable options for your system. For DOC 2000, it only can be set as 3rd or 4th drive (drive C or D) as the DOC is to simulate a harddisk. If you set it as 1st drive, that will cause the floopy drive A can't work properly. Save and exit this window after finishing the setup. (5). Boot up the system. You should see some information about DOC, like as " Ture FFS - BIOS.....". If not, please check the above steps. (6)After entering the DOS, Please check your DOC-2000 is ready-formatted or not. If not, use DOC's command to format it. Then, you can execute DOS commands and DOC-2000's command to use the SSD. Some special commands, which are provided by M-System, are different from the usual flash chips. To use as two DOC-2000 on any band of PCD-897 and PCM-3840 , please configure first disk to be C: and second disk to be D: by using "Dupdate.exe" in the utility disk DUPDATE D: /S:DOC106.EXB /First (as drive C:) DUPDATE /S:DOC106.EXE (as drive D:) or DUPDATE /win:C800 /S:DOC106.EXB /First (as drive C:) DUPDATE /Win:C800 /S:DOC106.EXE (as drive D:) Please type DUPDATE to get help You man also use DINFO.EXE to detace DOC-2000 chip. ###### Link 3 DOC-2000 ####################### To link multi DOC-2000, please u