Solution:

DOC-2000 Installation Procedure I. installation instructions 1. Make sure the target platform is powered OFF. 2. Plug the DiskOnChipR 2000 device into its socket. Verify the direction is correct (pin 1 of the DiskOnChipR 2000 is aligned with pin 1 of the socket). Also, refer to section 2.23 on POS-562 user manual to choose a suitable DOC-2000 address (JP4 DOC-2000 address setting) 3. Power up the system. 4. During power up you may observe the messages displayed by the DiskOnChipR 2000 when its drivers are automatically loaded into the system's memory. 5. At this stage the DiskOnChipR 2000 can be accessed as any disk in the system. 6. If the DiskOnChipR 2000 is the only disk in the system, it will appear as the first disk (drive C: in DOS). 7. If there are more disks besides the DiskOnChipR 2000, the DiskOn-ChipR 2000 will appear by default as the last drive, unless it was programmed as the first drive. 8. If you want the DiskOnChipR 2000 to be bootable: a . Copy the operating system files into the DiskOnChipR by using the standard DOS command (for example: sys d:). b . The DiskOnChipR should be the only disk in the systems or would be configured as the first disk in the system (c:) using the DUPDATE utility. DUPDATE D /S: DOC104.EXB /FIRST (set as c:) DUPDATE C /S: DOC104.EXB (set as d:) Note: In the above command, the DOC104 denotes DOC-2000 firmware version 1.04. If you get DOC-2000 utility disk version 1.05, you need to use DUPDATE D /S:DOC105.EXB /FIRST and so forth. II. Reference: 1. DOC-2000 product manual and technical document is available in M-Systems web site. Here is a list for current available document. DOC-2000 - Designing with the DiskOnChip 2000 DOC-2000 - DiskOnChip -EVB User Manual DOC-2000 - DiskOnChip 2000 - Compatibility List DOC-2000 - DiskOnChip 2000 Data sheet DOC-2000 - DiskOnChip 2000 Evaluation Board DOC-2000 - DiskOnChip 2000 PIK User Manual Rev 2.0 (Programmer and Integrator) DO